Supervisor Operations

Device Screen

This screen is used to set up the configuration for the device. For the IntelliSight processor, this screen will display in a quad format, an image for each active IntelliSight camera connected to the processor. The order of display is dependent on which cameras were added as Camera 1, Camera 2, Camera 3, and Camera 4. Camera 1 will display in the upper left; Camera 2 in the upper right; Camera 3 in the lower left; Camera 4 in the lower right.

1

Actions that can be performed. For information see:

2

Commands that can be executed. Restart Devices Restarts the selected device. Save Archive Captures the current state of a device. Restore Archive Downloads the contents of a previously saved archive file into the selected device. Clear Configuration (Only appears when the device is an IntelliSight Camera) Removes the configuration for an IntelliSight Camera. This includes all zone set up information and the camera calibration.

3

Display Window Shows a snapshot from the device and any detection zones that are already defined. For IntelliSight processor devices, a snapshot from each connected IntelliSight camera appears.

4

Camera Setup (Only appears when the device is an IntelliSight camera) Used to zoom the camera in and out.

5

Camera Calibration (Only appears when the device is an IntelliSight camera) Perform Calibration for the sensor. Required before Zone Setup can be done.

6

Zone Setup (Only appears when the device is an IntelliSight camera) Set up the detection zones. Requires Camera Calibration be done before option is active.

7

8

9

Shows device status messages
Snapshot/Video Controls Click to refresh the image, play video, record video, and stop video.
Version of the Supervisor software currently running on the computer.
Version 4.3.1 - Copyright © 2024, Image Sensing Systems, Inc. All rights reserved.