Configuring IntelliSight Devices: Zone Setup

Add Zone From Calibration

1. On the Device screen for the camera, click ZONE SETUP.
2. Click ZONES FROM CALIBRATION. 3. Select the lane layout from the list.
  • No Turn Lanes: one zone appears, covering all lanes defined in the calibration.
  • Left Turn Lanes: two zones appear, one for a left turn and one covering the remainder of the lanes defined in the calibration.
  • Right Turn Lane: two zones appear, one for a right turn lane and one covering the remainder of the lanes defined in the calibration.
  • Left and Right Turn Lanes: two or three zones appear, one for a right turn lane, one for a left turn lane and if more than two zones where defined in the calibration, one covering the remainder of the lanes.
  • Preserve All Lanes: a zone for each lane defined in the calibration appears.
The zone layout done on the calibration screen appears on the image and the lanes are defined according to the selection. Right-click on a zone to see its defined direction; if neither Right Turn nor Left Turn are checked, the zone is a through zone.
4. For zones not already designated as right or left turn, and it vehicles can exit the zone by making a right or left turn, do the following.
  • Right-click on the zone.
  • Under Turn Direction, select the appropriate check box.
  • Click elsewhere on the image.
5. Modify zone positions as required. 6. To change the zone description, highlight the description in the Easy Setup section and type a new one. Any number of alphanumeric and special characters can be used. 7. Assign conditions, actions, and video overlays as required. NOTE:
  • By default, the vehicle presence condition is selected for each zone. In addition, green is selected for the zone display color when a vehicle is detected and gray when no vehicle is present in the zone. There is no default output assigned.
  • For each selected condition (vehicle and bicycle differentiation) an output must be assigned unless the Set Output action is removed in the Zone Explorer or Actions Explorer section.
  • The Show Video Overlay check box is used to display overlays only when video is playing. The Show Setup Controls check box is used to display overlays on the Zone Setup screen for both static images and video.
  • After all zones are defined and configured, it is recommended that the configuration be archived (see Save Archive).
8. When complete, click APPLY CHANGES. Changes go into effect immediately and can be viewed live.
Version 4.5.0 - Copyright © 2025, Image Sensing Systems, Inc. All rights reserved.