Configuring IntelliSight Devices: Zone Setup

Add Zones Manually

1. On the Device screen for the camera, click ZONE SETUP.
2. Click ADD ZONE.
3. Move the cursor to one of the corner markers, then click and drag to the desired location. The arrows at the corners of the zone can be used to rotate the zone. 4. Repeat for each corner until the zone covers the detection area and lane lines are arranged so that they line up with the zone lines.
5. To add additional zones similar to the previous one, right-click on the previous lane to display the following. Otherwise, just click ADD ZONE and repeat step 3 and step 4.
6. Select whether the new zone is to be added to the left or right of the current zone. The new zone is added to the configuration. NOTE: Because the original zone is probably not a perfect square or rectangle, the distance measurement shown for the new zone will be different from the original. 7. Adjust the corner markers as required. 8. Can a vehicle make a right or left turn to exit the zone?
Yes
No
  • Right-click on the zone.
  • Under Turn Direction, select the appropriate check box.
  • Click elsewhere on the image.
  • Continue with the next step.
Continue with the next step.
9. Add additional zones as required. The following shows a total of two zones that have been defined for the through lanes.
10. To change the zone description, highlight the description in the Easy Setup section and type a new one. Any number of alphanumeric and special characters can be used. 11. Assign conditions, actions, and video overlays as required. NOTE:
  • By default, the vehicle presence condition is selected for each zone. In addition, green is selected for the zone display color when a vehicle is detected and gray when no vehicle is present in the zone. There is no default output assigned.
  • For each selected condition (vehicle and bicycle differentiation) an output must be assigned unless the Set Output action is removed in the Zone Explorer or Actions Explorer section.
  • The Show Video Overlay check box is used to display overlays only when video is playing. The Show Setup Controls check box is used to display overlays on the Zone Setup screen for both static images and video.
  • After all zones are defined and configured, it is recommended that the configuration be archived (see Save Archive).
12. When complete, click APPLY CHANGES. Changes go into effect immediately and can be viewed live.
Version 4.5.0 - Copyright © 2025, Image Sensing Systems, Inc. All rights reserved.