This protocol indicates that data can be retrieved through the queries from the Data tab, the RTMS Echo APIs or from the following Wavetronix Z1 protocols.

NOTE: The selection for Legacy protocols should be made before the selections in the Interval data section.

*Classification Configuration Message (0x13; read only)
Clear Event FIFO Message (0x6D)
Get Presence Message (0x68)
*Get Variable Size Interval Data (0x72)
Global Push Mode Message (0x0D; read only)
Legacy Active Lane Information Message (0x17; read only)
**Legacy Approach Information (0x11; read only)
*Legacy General Configuration Message (0x00; read only)
Sensor Time Message (0x0E; read only)
*Speed bins Configuration (0x1D; read only)

*These messages require configuration settings in the Interval data section.
**RTMS Echo does not currently support configuring approaches.

NOTE: Even though RTMS Echo supports up to 12 zones, the Wavetronix Z1 protocol only supports a maximum of 10 zones. Therefore, only 10 zones should be configured in the system (see Detecting Zones).

Click the Settings tab.
In the Legacy protocols section, click Change.

3.  For Protocol, select Wavetronix Z1.

4.  Select the Enable data push check box to only transmit data messages at the end of every message period. If unchecked, data messages are only retrieved on request (polled mode).

5.  Select the Include direction check box to have vehicle data binned by direction.

Bin 0 is the count of all vehicles that traveled in the same direction assigned to their respective lane. Bin 1 is the count of all vehicles that traveled in the opposite direction assigned to their respective lane.

6.  For Sensor subnet, enter the subnet on which the Echo sensor is located.

The value must be from 1 to 254. Do not use 255.

7.  For Sensor ID, enter the ID of the Echo sensor.

The value must be from 1 to 65534. Do not use 6553. The default is the first five digits of the serial number.

8.  For Destination subnet, when Enable data push is selected enter the subnet on which the device receiving the data is located. Not used when Enable data push is unchecked. 

NOTE: A value of 255 indicates that messages will be transmitted to all devices on the subnet.

9.  For Destination ID, when Enable data push is selected, enter the identification of the device to receive the messages. Not used when Enable data push is unchecked.

NOTE: A value of 65535 indicates that the device will receive all messages sent to the subnet.

10.  For TCP/IP port, enter the port number used for the Echo sensor.

11.  If a change was made, click Save changes.

Version 2.0 - Copyright © 2022, Image Sensing Systems, Inc.  All rights reserved.

Web App Operation

Legacy Protocols: Wavetronix Z1 Protocol