Installation and Setup: Camera

Changing the IP Address

This section provides information on changing the IP address for the camera.

• The camera will automatically self-assign an IP address if connected to a network without a DCHP server configured.
• To set a static IP address, select Static from the Network Settings drop down.

3. Enter the appropriate network parameters.

NOTE: Be sure to configure the DNS settings if NTP will be used and the NTP server is not an IP address.

4. When all settings have been configured, select Set at the bottom of the page. If the IP address has changed, the following message will appear.

5. Re-connect to the camera by typing the new IP address in the address bar of the Internet browser. 6. To change the HTTP port, select Setup from the sidebar menu, then select Network. 7. Find the HTTP port setting.

8. Change the value to the desired number.

Version 2.0 - Copyright © 2022, Image Sensing Systems, Inc. All rights reserved.